KDR-AU and Primary U-Arm Calibration FW V37 and Higher [UE13K05]
Overview:
With the introduction of stand firmware version 37 and higher, the calibration that is performed for position settings of motors M1-M5 has changed. This training will outline the new procedure.
Additional Information:
Course Objective:
Provide the necessary knowledge for the learner to be able to perform the calibration procedure.
- Setting the degree positions for M1 and M5
- Setting the start and end positions for motors M2 through M4
- Setting Upper Limit
- Checking proximity sensors
- Other checks
Course Prerequisistes:
The learner must have attended a training course conducted by Konica Minolta that included the KDR Advanced/Primary U-Arm System.
