CS-7 One Shot Stitching – Rev 2 [UE13K05]
Overview:
The following training provides instruction on how to perform installation and service for the CS-7 One Shot Stitching system using narrated multimedia video instruction and written instruction.
Additional Information:
Course Objective:
Provide the necessary knowledge for the learner to be able to perform installation and service for the CS-7 One Shot Stitching system.
This self-paced training course is meant as an aid to the documented Installation Procedure for the One Shot Stitching Image Device located in the CS-7 Installation Service Manual and is not a substitute for this procedure. Read through and follow the installation instructions in the service manual.
Course topics include the following:
- What is CS-7 One Shot Stitching
- How to configure CS-7 One Shot Stitching
- How to calibrate CS-7 One Shot Stitching
- How to make a test exposure and interpret the user interface icons
- Possible errors
Rev 2 of this training course includes new information received from Konica Minolta Japan for the One Shot Stitch System
Chapters designated with a * are either new or have been updated. If you have previously taken this course, thoroughly review these sections.
What is new in Rev 2:
- Introduction of One Shot Markers
- New CS-7 setting to set the type of Panel Holder used in the One Shot Stitch Stand
- Troubleshooting possible image artifacts
- Initial Exam Tag configuration has been added
Course Prerequisistes:
Attendance to a Konica Minolta instructed CS-7 AeroDR Service Training class.
